Berg Drive-Through Spill Containment Berm, 15′ x 50′ x 12″, 7,045 Gal.

The Berg Drive-Through Spill Containment Berm (15 ft x 50 ft inside, 12 in. walls) holds up to 7,045 gallons of spilled liquid for secondary containment.

A drive-through berm with self-rising ends and aluminum L-brackets that hold the side walls up. Vehicles drive in one end and out the other while the berm catches oil, fuel and other fluids. Yellow tire track guards protect the liner in the drive path.

Inside it measures 15 ft wide by 50 ft deep with 12-inch walls and holds up to 7,045 gallons. It weighs about 373 lb. It helps facilities meet EPA 40 CFR 112.7 and SPCC secondary containment rules.

Good for

• Fuel trucks, tankers and mobile refueling
• Generators, compressors and heavy equipment
• Drum and tote staging areas
• Vehicle maintenance and wash bays
• Frac sites, job sites and emergency spill response

Specifications

Questions and answers

How much does the Berg Drive-Through Spill Containment Berm hold?

Up to 7,045 gallons, with 12 in. walls.

How do I size a containment berm?

Find the largest tank, tote or vehicle compartment that will sit in the berm. SPCC rules require the berm to hold that full volume plus room for rain, and a common rule of thumb is at least 110% of the largest container. Pick a berm whose capacity meets that number.

Can vehicles drive into it?

Yes. It is built for drive-in, drive-out use; the low walls let tankers and heavy equipment roll in and out without ramps.

What about rainwater in the berm?

Rain collects in an outdoor berm and uses up capacity, so check it after storms and remove clean water. A berm bailer or drain lets you remove water in a controlled way; never drain water that has a sheen.

Do I need a ground mat?

A ground mat or tarp under the berm protects the floor from rocks, rebar and rough ground, and track guards protect it where tires roll in. Both are in our Berm Accessories category.