PacTec L-Bracket Spill Containment Berm, 12′ x 25′ x 12″, 2,244 Gal.

The PacTec L-Bracket Spill Containment Berm (12 ft x 25 ft inside, 12 in. walls) holds up to 2,244 gallons of spilled liquid for secondary containment.

Rigid L-bracket side walls hold a steady 12-inch wall height with no inflating or manual raising. Use it indoors or out for generator fueling, equipment maintenance and portable fluid storage.

Inside it measures 12 ft wide by 25 ft deep with 12-inch walls and holds up to 2,244 gallons. It weighs about 106 lb. It helps facilities meet EPA 40 CFR 112.7 and SPCC secondary containment rules.

Good for

• Fuel trucks, tankers and mobile refueling
• Generators, compressors and heavy equipment
• Drum and tote staging areas
• Vehicle maintenance and wash bays
• Frac sites, job sites and emergency spill response

Specifications

Questions and answers

How much does the PacTec L-Bracket Spill Containment Berm hold?

Up to 2,244 gallons, with 12 in. walls.

How do I size a containment berm?

Find the largest tank, tote or vehicle compartment that will sit in the berm. SPCC rules require the berm to hold that full volume plus room for rain, and a common rule of thumb is at least 110% of the largest container. Pick a berm whose capacity meets that number.

What about rainwater in the berm?

Rain collects in an outdoor berm and uses up capacity, so check it after storms and remove clean water. A berm bailer or drain lets you remove water in a controlled way; never drain water that has a sheen.

Do I need a ground mat?

A ground mat or tarp under the berm protects the floor from rocks, rebar and rough ground, and track guards protect it where tires roll in. Both are in our Berm Accessories category.